Video: make a bracelet with a steel cable

Video: make a bracelet with a steel cable



We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

Always keen to decorate your jewelry box with new creations, Julien Navas offers you to learn how to make a simple bracelet using a steel cable. To your pliers!

Watch the video :

Make a bracelet: cable preparation

For your bracelet, you will need bracelet clips, flat and cutting pliers, a steel cable and a pretty pearl. Measure the length of cable needed by sliding it around your wrist. Then immediately slide the bead on the steel cable, because the operation will be impossible once the fasteners are installed. Your bracelet is almost ready, you just have to put the closure.

Make a bracelet: put the fasteners

Take your tie, and separate the two parts. At one end of your bracelet, slide a crimp bead, then pass one of the two parts of your clip. Make a small loop by ironing the steel cable in your pearl, and crush very hard using flat pliers. Then cut the protruding end of the cable with pliers. Perform the same operation on the other end of your bracelet, with the second part of the clip. Your bracelet is ready and like that of Julien Navas, it fits you like a glove. Watch the video Making a bracelet with a steel cable on Minutefacile.com. Produced by Minute Facile.